Dịch vụ - Dịch Vụ: Sản Phẩm & Dịch vụ - Thứ tư, 07 Tháng 9 2011 03:59
banner-mixjsc

Danh mục sản phẩm

Joomla Templates and Joomla Extensions by JoomlaVision.Com

Sản phẩm mới

Phụ kiện
Phụ kiện

Johndeere 120-450kVA
Johndeere 120-450kVA

Perkins 9-2.200kVA
Perkins 9-2.200kVA

Fiat 30-400kVA
Fiat 30-400kVA

Doosan 200-650kVA
Doosan 200-650kVA

Deutz Weichai 30-150kVA
Deutz Weichai 30-150kVA

Viễn thông 4-15kW
Viễn thông 4-15kW

Dân dụng 2.5-11.0kW
Dân dụng 2.5-11.0kW

Bản đồ công ty

Thông báo: Trình duyệt của bạn không chấp nhận Cookies. Để đưa hàng vào giỏ và thanh toán bạn phải cho phép Coockies.
Doosan 200-650kVAFiat 30-400kVA

Downstream Equipment


Downstream Equipment - Air treatment methods

Aftercoolers

Aftercoolers are a good first step in removing moisture and air contaminates. They lower the temperature to safe, usable levels, thus reducing the air's ability to hold water vapour, removing 70%. However the air is still saturated. A further drop in temperature will cause additional condensation to occur in downstream airlines.

Refrigerant drying

Refrigerant drying cools the compressed air, whereby a large amount of the water condenses and can be separated. The compressed air is then heated so that condensation does not form on the outside of the pipe work system.

The compressed air cooling takes place, via a closed coolant system, where a refrigerant cooling agent is employed. CompAir uses environmentally friendly gasses for this. By cooling the compressed incoming air with the cooled outgoing air in the heat exchanger, the energy of the refrigerant dryer is reduced.
Desiccant Drying

Desiccant drying works on the principle of absorption of water vapour through a bed of desiccant material, in a pair of chambers. Two types are used, heatless regenerative and heat regenerative. The heatless type uses a percentage of the dried air (purge), for re-generation of the desiccant material, while the heat regenerative type uses an electric heat disk, which reduces the amount of purge air needed for regeneration.

Filters and Water Separators

WS Water Separators have been designed for the efficient removal of bulk liquid contamination from compressed air. Filters are used both prior to, and after compression. Filtering the intake air reduces the intake wear on the compressor by removing larger particles. During the compression air can be contaminated with oil (in oil lubricated machines) which is removed by filters. The filter efficiency is dependant on compressor type, age, design and condition. Filters are often setup in multistage. Fibre filters can only trap oil as droplets, while more efficient active carbon can trap oil as a vapour. We can help you select the right filters for your needs.


Joomla! Template design and develop by JoomVision.com - http://www.joomvision.com